Massa M3 Manuel d'utilisateur télécharger pdf (Page 7)

Instruction Guide – Massa M3 Wireless Sensor Evaluation Kit Page of 14

M3 Kit Guide 111017.docx 10-20-2011

PRELIMINARY

M3 Application Software

Automatic Sensor Data Collection

Collecting the measurements taken by the Sensor over a period

of time can be performed automatically using the M3 Software’s

“AutoSend Monitor” tab. The Sensor can be configured to

automatically send data by clicking the “Settings and Info” tab

and entering the desired values as shown in the figure to the

right. In this example, the data collection interval has been set to

3600 seconds (1 hour). After entering the desired settings, click

“OK” to program them into the Sensor.

Select “AutoSend Monitor” menu item and the

screen shown in the figure on the right will

appear. Click on “Edit File Path” if you prefer

another location to save the file other than the

default path. To start saving data to file, click the

“Save Data to File “box. The numbers occurring in

the “Bytes Received” box indicate incoming data.

The data is stored as a spreadsheet, file type (.csv),

as is shown in the figure below. Each “AutoSend”

message will contain up to 8 historical blocks of

data. In this example, the Event numbers are in

one hour increments with the highest Event

number being the latest data acquired.

Note:

A range of 510 inches represents a cleared record.

Example of Auto Send Messages Saved to an Excel File

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Massa M3 Manuel d'utilisateur Page 7